Poisson’s ratio determination of Au nanofilms by piezoresistive measurements
- A. I. Oliva,
- G. G. Comparán-Rodriguez,
- V. Sosa,
- A. I. Oliva-Avilés(autore corrispondente)
- Centro de Investigacion y de Estudios Avanzados del Instituto Politécnico Nacional,
- ,
- ,
Prodotto della ricerca:
Contribution to journal
Article
Research
Peer reviewPublication Information
Tipo di output
Prodotto della ricerca:
Contribution to journal
Article
Research
Peer reviewLingua originale
EnglishPagine da-a (Numero di pagine)
Pagine 8563-8571 (9 pagine)Rivista (volume, numero edizione)
Journal of Materials Science (Volume 58, Edizione 20)Attività cardine della pubblicazione
- Published - 01/05/2023
Stato pubblicazione
Published - 01/05/2023
ISSN
0022-2461ID pubblicazione
- Scopus: 85158141996
Abstract
<p>A methodology for determining the Poisson’s ratio (ν) of Au films with nanometric thicknesses is proposed. Au films with thicknesses of 10, 20, and 40 nm were thermally evaporated onto polyimide substrates (Kapton® 300HN) and electrodes were attached for the electrical measurements. The thermal coefficient of resistance of the Au films was estimated at the first stage of heating, caused by Joule effect, where electrical resistance and temperature followed a linear dependence. When thermal stabilization of the Au/polyimide system was reached, it was subjected to axial strain within an elastic regime and the electrical resistance of the metallic film was continuously recorded. The gage factor (piezoresistive sensitivity) of the Au nanofilms was measured and used for the estimation of the Poisson’s ratio according to its definition for metallic materials. A value of ν = 0.50 was estimated for the Au thin films, being slightly higher than the Au bulk value (ν<sub>bulk</sub> = 0.42).</p>
Access to documents
Publication metrics
Metriche
SciVal
FWCI
0.20
PlumX, si apre in una nuova scheda
Mentions
1
Captures
2
Citation count
3
